A client has a cable reel assembly that consists of two winged holders and a grooved wheel that functions as pulley for a cable reel system on a machine. Due to material degrading over the years, one of the winged piece snapped as shown in the picture…

A vessel docked in local (Singapore) yard was in need to change its damaged rudder stock urgently. To proceed with the replacement, data collection of dimensions and alignment of existing rudder sub-assembly (rudder blade, rudder neck and rudder horn pintle) is necessary before carrying out new rudder stock installation deliver from Europe…

A winch manufacturer was seeking for solutions to enlarge and deepen bolt holes on its supplied turret riser winch to increase the permissible heave in torque by request from the turret designer. As the winch is already housed on board an operating FPSO at…

Metal Machines received an enquiry from a client located in Malaysia to conduct onsite machining on one of the renewed ball mill’s bearing mounting flangesUpon studying the engineering drawing for the GD&T requirement, we realise this is not a straight forward machining task…

A client’s pipe laying vessel was in need for repair on its key pipe-laying equipment, the stinger. Due to the work nature, pipe laying vessel’s stinger is often subjected to high loading in harsh sea condition in which caused the bushes in the brackets and locking load cell pins that…

An offshore floating structure located in Panama needs a new key component to be changed out to remain operational. The new component is going to be fabricated in Europe and shipped over to replace the malfunction set at site. The component is connected to 3 welded….

A client located in Sri Lanka initially engaged a local in-situ service provider to conduct machining on 3 jetty cranes’ foundation baseplates; after several attempts, the service provider is still unable to fulfil the crane manufacturer’s required specification. With uncertainty insight for…

A client in Singapore was sourcing for a large scale CNC equipped machine shop to bore additional groove for a batch of 140 riser pipes connectors. Due to this is a last minute site specification change for an offshore project, this modification is needed to carry out in very short time…

An elevator’s motor shaft in a commercial building located at Singapore CBD area was found having excessive wear and chipped off damage at the bearing mounting area’s edge (shown in the photo below) during its periodic maintenance inspection. As the protocol from…

A client in the automotive industry has an existing engine holding jig and its key function is to rotate the engine for easier access of parts removal. The limitation is that the holding frame is at a fixed elevation and unable to perform a 180° rotation due to the engine overall height…

A feedstock process company located in Singapore, had encountered a badly worn off drive shaft on one of its key production ovens. The shaft is driven by a motor and supported by a bearing. The area where the bearing in contact with the shaft, is constantly subjected to…

Congratulation to our client, Goldbell Engineering Pte Ltd (8 Tuas Ave 18, Singapore 638892) for the inauguration of their new Multi-storey integrated workshop located.